Table of Contents
Advertisement
1-4 Getting Started
1.
area, the signal strength bar will be displayed.
2.
： Displayed after picking up the receiver (off-the-hook).
3.
： Displayed when the alarm function is enabled.
4.
：
R
5.
：
6.
information on the electric energy left in the battery.
7.
： Displayed when AC power is applied.
8. Message Display Area
number and other messages.
Note:
When the battery is used to provide electric power upon power failure, do not remove the
battery once exhausted. When normal power resumes from the power adaptor, it will
gradually recharge the battery. The resulting battery icon display will register as full.
When the battery is used in the event of power failure, the battery icon will flash and a low
capacity alarm will sound every 30 seconds if battery capacity is insufficient. After 3 audible
alarms, if the power is still not restored, the display will blackout and the phone will stop
working.
1.3.3
Adjust Phone Height
The phone height can be adjusted by changing the angle of the stand on the
base.
1. Turn the phone upside down with the base facing upward.
2. Press "PRESS", located in the center of the stand with thumb, while pressing
the side with the black rubber foot to increase the angle between the stand and
the base of the phone (see the following figure):
If the angle between the stand and the base of phone has reached the
maximum setting, stop applying pressure to prevent damage to the stand .
：
Indicate signal strength. When the phone is within a service
Displayed if the ring is not set to "OFF".
Indicating that there is a RJ11 extension in use.
：
Displayed when a battery is connected. This icon gives
Display of date, time, menu content, phone
FSU811 User Guide
Advertisement
Table of Contents
