Table of Contents
Advertisement
Checking the Radio System
CAUTION: Always keep all body parts, hair
and dangling or loose items away from a spinning
propeller, as these could become entangled.
NOTICE: Always power on the transmitter before
powering on the ESC. Always power off the ESC
before powering off the transmitter. Never transport
the boat with the battery connected to the ESC.
1. Turn the transmitter throttle and steering trim knobs
to the 10 o'clock position.
left
Binding
Binding is the process of programming the receiver to
recognize the GUID (Globally Unique Identifier) code of a
single specific transmitter. The included transmitter and
receiver are bound at the factory. If you need to rebind,
2.4GHZ DIGITAL
RADIO SYSTEM
follow the instructions below.
1. Power OFF the ESC/Receiver and transmitter.
2. Connect a fully charged battery to the ESC/Receiver.
3. Power ON the ESC/Receiver. It will beep once and
the LED will flash rapidly, indicating it is in bind mode.
4. To put the STX2 transmitter into bind mode, hold the
steering wheel fully to the right while powering on the
transmitter.
Release the steering wheel after 2 seconds.
5. The LED on the ESC/Receiver will go solid and the
ESC/Receiver will make a rising tone, indicating the
bind is successful.
You must rebind when binding the receiver to a different
transmitter.
NOTICE: Do not attempt to bind the transmitter and
receiver if there are other compatible transmitters in
bind mode within 400 feet. Doing so may result in
unexpected binding.
INSTRUCTION MANUAL
2. Power on the transmitter.
3. Connect a fully charged battery to the ESC.
4. Power on the ESC. The boat will beep 5 times.
5. Ensure the rudder moves in the proper direction
when the steering wheel is moved left or right.
6. Pull the throttle to full, then return the throttle to
neutral, ensuring the propeller turns counterclockwise.
The auto-sensing voltage cutoff will also engage when
the ESC detects a low battery charge. Release the
throttle and recharge the battery.
right
throttle
Failsafe
In the unlikely event that the radio connection is lost
during use (possibly due to low transmitter batteries
or distance between the receiver and transmitter), the
receiver will hold the steering at the last command with
no throttle.
If the receiver is powered on before powering on the
transmitter, the receiver will enter this failsafe mode.
When the transmitter is powered on, normal control is
resumed.
brake/reverse
2.4GHZ DIGITAL
RADIO SYSTEM
2.4GHZ DIGITAL
RADIO SYSTEM
EN
7
Advertisement
Table of Contents
