Goggle Setup; Tech Remote (Talk Box); Visuastim Controller - Siemens Prisma 3T User Manual

Tech Remote (Talk Box)

1. To change any settings on the Tech Remote intercom you will need to scroll the far right
wheel "Menu" to the appropriate setting - press down on the wheel - scroll to change the
setting - press down again to lock in that setting
2. Connect the goggle VGA cable to the laptop or select "GOGGLES" on the "desktop
switch box" if you are using the desktop computer
3. Connect the appropriate audio cable (res tech or opto) to the computer you will be using
 Laptop: the audio cable connects directly to the laptop
 Desktop: the res tech audio cable connects to the audio jack in the white drawer
labelled "AUDIO TO DESKTOP"
4. Make sure the computer is on (BMC Mac laptop, your laptop or the Dell Desktop)
5. Go to Menu on the "Tech Remote," and set the "Video Mode" (what the participant sees)
If you want the participant to see
the laptop
6. Go to Menu on the Tech Remote and turn on the "System PWR" (turn this off when you
are done with your scan)
7. "Visor PWR" should always be on (do not turn off after scan)
Red Light
8. DO NOT assume that the display on the "Goggles" monitor will be correctly mirrored to
the goggles – always verify the correct display is being projected by physically looking
through the goggles during protocol development scans or by asking the participant to
describe what they see on the screen

Visuastim Controller

1. On the "Visuastim Controller," make sure the "Monitor Input" (what the researcher sees
on the "Goggles" monitor) is set to:
31

Goggle Setup

If you want the participant to see
the Dell Desktop
Blue Light
Revision Date: 3/13/2019