Usb Ports - DFI AL102 User Manual

USB Ports

PTN
3460
USB 3.0
USB 1
USB 0
USB 4
USB 2
USB 3.0
USB 9-10 USB 7-8
2
1
USB 2.0
The USB device allows data exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
The system board is equipped with 4 onboard USB 3.0 ports (USB 0-1/2-4) at the rear panel
I/O ports. The 10-pin connectors allow you to connect 4 additional USB 2.0 ports (USB 7-8/9-
10). The 5-pin connector allows you to connect 1 additional USB 2.0 port (USB 3).The ad-
ditional USB ports may be mounted on a card-edge bracket. Install the card-edge bracket to
an available slot at the rear of the system chassis and then insert the USB port cables to a
connector.
BIOS Setting
Configure these onboard USB devices in the Advanced menu ("USB Configuration" submenu)
of the BIOS. Refer to the chapter 3 for more information.
Driver Installation
You may need to install the proper drivers in your system operation to use the USB device.
Refer to your operating system's manual or documentation for more information.
Chapter 2 Hardware Installation
PTN
3460
USB 3 or
Vertical USB 3 (opt.)
10
9
1
5
USB 2.0
Chapter 2
Wake-On-USB Keyboard/Mouse
The Wake-On-USB Keyboard/Mouse function allows you to use a USB keyboard or USB mouse
to wake up a system from the S3 (STR - Suspend To RAM) state.
17
www.dfi .com