Rear Panel I/O Ports
COM 1
COM 2
DC-in
HDMI
VGA
The rear panel I/O ports consist of the following:
•
1 DC-in
•
2 Serial COM ports
•
1 HDMI port
•
1 VGA port
•
2 RJ-45 LAN ports
•
4 USB 3.0 ports
•
1 Line-out jack (optional)
Chapter 2 Hardware Installation
Chapter 2
LAN 1
LAN 2
Line-out (opt.)
USB 3.0
12V DC-in
DC-in
PTN
3460
This 4-pin vertical type connector is considered a low power solution. Connect a DC power
cord to this connector. Using a voltage more than the recommended range may fail to boot
the system or cause damage to the system board.
The 4-pin vertical type connectoron the system board co-lays with a DC-in jack (optional) or
4-pin right angle connector (optional) as the photo displayed below.
4-pin Right Angle
(optional)
15
PTN
3460
4-pin Vertical Type (default)
DC-in (optional)
www.dfi .com