Table of Contents
Advertisement
5. Grasping the module by its edges, align the module into the socket at an approximately 30
degrees angle. Apply firm even pressure to each end of the module until it slips down into
the socket. The contact fingers on the edge of the module will almost completely disappear
inside the socket.
6. Push down the module until the clips at each end of the socket lock into position. You will
hear a distinctive "click", indicating the module is correctly locked into position.
Clip
Chapter 2 Hardware Installation
Chapter 2
Jumper Settings
Clear CMOS
Clip
If you encounter that CMOS data becomes corrupted, you can reconfigure the system with the
default values stored in the ROM BIOS.
To load the default values stored in the ROM BIOS, please follow the steps below.
1. Power-off the system and unplug the power cord.
2. Set JP6 pins 2 and 3 to On. Wait for a few seconds and set JP6 back to its default setting,
pins 1 and 2 On.
3. Now plug the power cord and power-on the system.
10
JP6
PTN
3460
PTN
3460
3
2
1
1-2 On:
Normal (default)
3
2
1
2-3 On:
Clear CMOS
www.dfi .com
Advertisement
Table of Contents
