Smbus Connector; Standby Power Led - DFI AL102 User Manual

SMBus Connector

5
SMBus_Alert-
SMBus_Data
SMBus_CLK
GND 3V3SB
2 1
The SMBus (System Management Bus) connector is used to connect SMBus devices. It is a
multiple device bus that allows multiple chips to connect to the same bus and enable each one
to act as a master by initiating data transfer.
Chapter 2 Hardware Installation
Chapter 2
PTN
3460
PTN
3460

Standby Power LED

PTN
3460
This LED will lit red when the system is in the standby mode. It indicates that there is power
on the system board. Power-off the PC and then unplug the power cord prior to installing any
devices. Failure to do so will cause severe damage to the motherboard and components.
24
Standby Power LED
PTN
3460
www.dfi .com