Takeuchi TB285 Operator's Manual page 130

OPERATION
handling rubber crawlerS
• When climbing in reverse, do not change
directions at the point where the slope
starts.
• Avoid traveling by setting one crawler on a
slope or projecting portion and the other
crawler on a flat surface (with the machine
at a tilt of 10° or more). Travel with both
crawlers set on flat surfaces.
• Do not change directions when the crawler
belts are slack as shown in the figure.
• The rubber crawler belts will come off if the
machine travels backward in this condition.
• The rubber crawler belts will come off if the
machine turns in this condition.
3-28