Step 5 - Activate And Deactivate Additional Functions - Angelcare AC423 Owner's Manual

STEP 5 – ACTIVATE AND DEACTIVATE ADDITIONAL FUNCTIONS
The Angelcare ® monitor can be used with the pre-program factory settings
or you can also customize your settings to your preference.
5.1 - OUT-OF-RANGE
Your monitor has an Out-of-Range function that advises you when the Parent Unit
cannot receive the signal from the Nursery Unit. Out-of-Range situations can be
caused by distance or by physical interferences.
RANGE:
Up to 250 meters / 820 ft (open field)
TO ACTIVATE THIS FUNCTION:
Slide the Out-of-Range button
on the Nursery Unit
to turn it ON or OFF.
The Out-of-Range Indicator
will blinks on the Parent Unit.
OUT-OF-RANGE ALARM
• Alarm activates when your two units are not communicating.
• The Parent Unit will emit a double beep every 8 seconds.
• Out of Range Icon will flash on the screen.
IMPORTANT
If the Parent Unit is OFF after out of range function being set ON, it is needed to reset
and reactivate the function to ON again. To reset it, make sure the Parent Unit is ON
again and slide the Nursery Unit switch to OFF and then slide the switch to ON again
as to reactivate the Out of range function.
TO STOP THE OUT-OF-RANGE ALARM:
14
Press 2 seconds
OR
to turn the Parent
Unit OFF
ON
OFF
The Out-of range Icon will also flash
when channel is being changed or
the unit is reconnecting
Turn the Nursery
Unit ON