Beckman Coulter GH-3.8 Instructions For Use Manual page 9

Illustrations
1 The Micro Plus Multiwell Plate
2 Rotor Yoke and Centrifuge Drive Shaft. Be sure the pin in the
drive shaft is in the groove in the rotor
3 Rotor Tie-Down Nut and
4 Examples of Correctly and Incorrectly Loaded Buckets and
Carriers. Contents of opposing buckets must be the same and
each bucket must be balanced on its pivotal
5 The Bails (Vertical Supports) of the GH-3.8 (and GH-3.7) Modular
Disk Adapters and the J6 Series Adapters are Not the Same.
Bails for the GH-3.8 are straight and end in a disk; bails for
the J6 have curved ends. Do not intermix adapters (or disks
from adapters) between
6 Examples of the Effects on the Horizontal
Swing of Buckets Caused by Proper and Improper
Weight
7 Assembling a Modular Disk
8 Installing an Adapter in a Bucket. Be sure the bails (vertical
supports)
line up with the bucket pivot
9 Blood Bag Loading
10 Proper Placement of
11 Securing Bucket Cover
12 The Micro Plus Multiwell Plate Carrier, Base, Pad, and Deep-well
Plate, 26
13 Lubricating Pivot Pin/Bucket Contact
Carrier, 10
O-Ring, 14
sets., 18
Distribution, 19
Adapter, 20
pins., 21
Procedures, 23
O-Ring, 24
Latches, 24
Illustrations
yoke., 13
axis., 16
Areas, 32
ix