Adjust; Informaion Of The Device - ProLights RA3000Profile User Manual

RA3000PROFILE
16

3.15 ADJUST

This function allows you to change all parameters. Press the UP/DOWN buttons to select one of the param-
eters and press ENTER to change its value (000-999) using the UP/DOWN buttons.
Press the ENTER button to confirm your choice.
Press the LEFT button repeatedly to exit the menu and to save the changes made.
3.16 INFORMATION ON THE DEVICE
To view all the information on the device, proceed as follows:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to select Information, then press the ENTER button to access the next menu.
• Press the UP/DOWN button to scroll through the menu, then select one of the following information and
press the ENTER button to display it.
- Fixture Time - Through the Fixture Time function, the operating time of the projector can be shown on the
display.
- Temperature - Through the Temperature function it is possible to display on the display the temperature
inside the moving head, where the lamp is located. The temperature can be displayed in degrees Celsius
or Fahrenheit.
- Fans Speed - Through the Fans Speed function it is possible to display on the display the fan speed present
near the lamp. The speed measurement is expressed in RPM (revolutions per minute).
- Software Version - Through the Software Version function, the version of the installed software can be viewed
on the display.
- UID - Select the UID function to display the identification ID for the RDM control.
• Press the LEFT button repeatedly to exit the menu.
- DMX View - Select the View DMX function to display all DMX menu.
• Press the LEFT button repeatedly to exit the menu.