Event Log - Geotech G200 Operating Manual

G 2 0 0 R A N G E
Operating Manual

EVENT LOG

The following events are recorded in the instrument's event log. The event log can only be
downloaded using the additional Analyser Data Manager software. Please refer to the Analyser Data
Manager operating manual for further details.
Event
Cold Start/Reset
Firmware version
Set time
Set date
Re-flash requested
Restore to factory settings
Comms clear memory
Change contrast
Change flow fail current limit
RTC date/time invalid
Factory calibration invalid or overdue
Service invalid or overdue
Field/User Calibration invalid or overdue
O2 Cell replacement overdue
Pump replacement overdue
Battery replacement overdue
EEProm settings set to default
Missing EEProm settings initialised
CO cell replacement overdue
Power on self-test, sensor not found
Power in self-test, sensor out of range
Power on self-test, sensor out of range
Battery dropped below critical value
User calibration set zero OK
User calibration set span OK
User calibration set zero failed
User calibration set span failed
Attempt to store when readings memory full
Readings memory nearly full
Flow fail current limit exceeded
Automatic power off
Change logging mode
Change logging mode ID
Changing logging mode ID site
Flow fail current limit exceeded
An alarm has changed state
Change of alarm setting
Mode of instrument changed
www.geotechuk.com
Data
Type of start (MCUSR, boot_key)
Description
Before and After
Before and After
None
Type
Type 0=Readings, 1=Event Log
Before and After
Before and After
None
Date, Difference
Date, Difference
Time, Channel, Date, Age, Limit
Time, Channel, Date, Age, Limit
Used, Limit
Used, Limit
Which
Which, Orig Version, New Version
Time, Channel, Date, Age, Limit
Channel
Channel, Reading, Low, High
Channel, Reading, Prev
Limit, Actual
Before and After
Before, After
Target, Reading
Target, Reading
Max
Limit, Actual
Limit, Actual
Status, Interval, Pump time
ID
Site ID
Limit, Actual
Alarm, State, Actual, High, Low
Alarm, State, High, Low
Before, After
© QED Environmental Systems Ltd.
Page 55 of 61
OMG200N Iss.04