Alpha-Numeric Data; Instrument Status Icons - Geotech G200 Operating Manual

G 2 0 0 R A N G E
Operating Manual
Any mistakes can be corrected using the soft-key 'Delete' which will delete the last digit typed.
Alternatively, the sequence can be retyped before the 'Enter' key is pressed and the existing numbers
will be pushed off the screen.

Alpha-numeric Data

When entering site IDs, alpha-numeric codes may be specified. To enter characters select either '1-
Site' or '2-ID' followed by the 'Menu' key and the following screen is displayed:
The operator can choose upper and lowercase characters. Press the 'Menu' key again to choose
lowercase characters. Use the numeric keypad on the instrument to select the appropriate letter, i.e.
to select A 'Key 2', to select B 'Key 2' twice (just like on a mobile phone).
Note: The instrument will not allow invalid data to be entered; this should be deleted and re-
entered.

Instrument Status Icons

The following icons may be displayed on the instrument read screens:
Icon
(flashing)
(flashing)
(flashing)
(flashing)
(flashing)
Note: A red backlight is displayed if the pump is stalled or the alarm is activated. For further
www.geotechuk.com
Screen 1 – Enter site
Description
Battery charge state
< 1 hour remaining
Battery charging
Charged
Pump running
Pump stalled (Backlight turns red)
Alarm set
Alarm active (Backlight turns red)
USB connected to PC (flickers when transferring data)
Logging mode active (flashes when memory nearly full)
Temperature probe(s) connected
Humidity probe connected
Service due (every 12 months)
Service overdue
Fault/repair
Waiting
OMG200N Iss.04
© QED Environmental Systems Ltd.
Page 17 of 61