Table of Contents
Advertisement
G 2 0 0
R A N G E
Operating Manual
interval (if logging is enabled).
The peak value is reset after a reading is stored or by exiting the peak mode using the appropriate
soft-key. The current mode of operation can be identified by the status of the soft-key, either
'Normal' or 'Inverse', where inverse indicates peak mode is active.
Store Reading
The 'Store' reading option allows the operator to store the current reading. Upon selecting this
option the operator is then prompted to enter or select a 'Site ID' and 'Sample Point ID' to identify the
reading. Select the 'Accept' button to confirm the ID choices. For further information please refer to
section
Enter ID
Codes.
Hold Reading
The 'Hold' reading option allows the operator to freeze the currently displayed reading. This allows it
to be manually recorded or moved away from the sample point. Once activated, press the soft-key
'Hold' and the readings are fixed until the 'Hold' key is pressed again or the reading is stored.
The current mode of operation can be identified by the status of the soft-key which is inversed whilst
in the hold phase.
Logged Reading:
Logged readings need to be configured and initiated via the 'Utilities' menu by pressing 'Key 6 -
Logging'. During configuration the user will be asked to supply an ID, reading interval and pump run-
time.
These parameters are used to control the reading frequency in logging mode. Once logging mode is
activated the instrument will automatically record a reading at every interval until stopped by the
operator or the memory becomes full. Logging is also suspended temporarily whilst the user is
accessing the menu options.
Whilst the logging mode is active both the 'Pump' and 'Store' key will be deactivated; only logged
readings can be stored.
Enter ID Codes
ID codes are either created at the time of selection on the analyser or created using the Analyser Data
Manager software and uploaded to the instrument for selection prior to readings being taken.
The 'Site' (top level ID) and 'ID' (second level ID) fields refer to the identifier that the operator gives to
a reading set before it is stored. The G200 and G210 allows the operator to enter up to 16 alpha-
numeric characters which are split into two parts (to help manage the data) called 'Site' and 'ID' by
www.geotechuk.com
Screen 3 - Hold reading
OMG200N Iss.04
© QED Environmental Systems Ltd.
Page 20 of 61
Hide quick links:
Advertisement
Table of Contents
