Advertisement
32
17
FIGURE 4
STEP 4
• Slide one ACCORDION SLEEVE (24) and two PILLOW BLOCKS (17) over the PIVOT ARM (4) as shown in FIGURE 4
• Assemble four 3/8 X 3" BUTTON HEAD CAP SCREWS (13) and four STARLOCK WASHERS (32) to the the PILLOW
BLOCKS (17) as shown in FIGURE 4
1A
TIGHTEN!
SET SCREWS
FIGURE 5
STEP 5
:
• SECURELY assemble the PIVOT ARM (4) to the CROSS SUPPORT (3) using four previously inserted 3/8 X 3" BUTTON
HEAD CAP SCREWS (13), four RH WASHERS (16), four 3/8" SAE WASHERS (15), four 3/8" LOW HEIGHT LOCK NUTS
(14) and four RH CAPS (33) as shown in FIGURE 5.
• Assemble one RUBBER BUMPER (22) to the CROSS SUPPORT (3) where the PIVOT ARM (4) shaft contacts tube.
• IMPORTANT! When PIVOT ARM (4) is centered and level in the PILLOW BLOCKS (17), tighten the PILLOW BLOCK set
screws.
13 3/8 X 3"
BUTTON HEAD
24
4D
4
13 3/8 X 3" BUTTON HEAD
22
3
7
4B
4
16
15
14
33
4A
4C
Advertisement
