Global Address Pool-Based Dhcp Server Configuration; Configuration Overview; Enabling Dhcp - H3C S3600 Series Operation Manual

Operation Manual – DHCP
H3C S3600 Series Ethernet Switches-Release 1510
If no IP address is available, the DHCP server queries lease-expired and
conflicted IP addresses. If the DHCP server finds such IP addresses, it assigns
them; otherwise the DHCP server does not assign an IP address.

2.2 Global Address Pool-Based DHCP Server Configuration

2.2.1 Configuration Overview

Table 2-1 Configure global address pool-based DHCP server
Enable DHCP
Configure global address pool mode
on interface(s)
Configure the
interface(s) to
operate
global
address pool
mode
Configure DNS services for the
DHCP server
Configure NetBIOS services for the
DHCP server
Customize DHCP service
Configure the gateway IP address
for DHCP clients
Configure the connection between
the DHCP global address pool and
the BIMS server

2.2.2 Enabling DHCP

You need to enable DHCP before performing other DHCP-related configurations, which
takes effect only after DHCP is enabled.
Configuration task
Configure to bind IP
address statically to
a DHCP client
in
Configure to assign
IP addresses
dynamically
Chapter 2 DHCP Server Configuration
Description
Required
Optional
One of the two
options is
required. Only
one mode can
be selected
for the same
global
address pool.
Optional
Optional
Optional
Optional
Optional
2-4
Related section
2.2.2 "Enabling DHCP"
2.2.3 "Configuring Global
Address Pool Mode on
Interface(s)"
2.2.4 "Configuring How to
Assign IP Addresses in a
Global Address Pool"
2.2.5 "Configuring DNS
Services for the DHCP "
2.2.6 "Configuring DHCP
Server"
2.2.7 "Customizing DHCP
Service"
2.2.8 "Configuring
Gateway Addresses for
DHCP Clients"
2.2.9 "Configuring
Connection Between
DHCP Global Address
Pool and a BIMS Server"
a