Option 184 Supporting Configuration; Introduction To Option 184 - H3C S3600 Series Operation Manual

Hide thumbs Also See for S3600 Series:
Table of Contents

Advertisement

Operation Manual – DHCP
H3C S3600 Series Ethernet Switches-Release 1510
Note:
To enable option 82 normally, you need to perform corresponding configuration on both
the DHCP server and the DHCP relay. For the configuration of the DHCP relay, see
section 3.1.3 "Option 82 Supporting".

2.6 Option 184 Supporting Configuration

2.6.1 Introduction to Option 184

Option 184 is an RFC reserved option, and the information it carries can be customized.
H3C defines four proprietary sub-options for this option, enabling the DHCP server to
put the information required by a DHCP client in the response packet to the client.
I. Basic concept
The four sub-options of option 184 mainly carry information about voice. The following
lists the sub-options and the carried information:
option: An option in a DHCP message. This option may be a field in variable length.
Option contains some lease information and message types. The option field
contains at least one and up to 255 options.
Sub-option 1: IP address of the network call processor (NCP-IP).
Sub-option 2: IP address of the alternate server (AS-IP).
Sub-option 3: Voice VLAN configuration.
Sub-option 4: Fail-over call routing.
II. Meanings of the sub-options for option 184
Table 2-23 Meanings of the sub-options for option 184
Sub-option
NCP-IP
(sub-option 1)
Feature
The IP address of
the
carried
sub-option
The
NCP-IP
option
sub-option carries
intended
the IP address of
identifying
the network call
server serving as
processor (NCP).
the
controller and the
server
application
downloading.
2-23
Chapter 2 DHCP Server Configuration
Function
NCP
server
by
1
of
184
is
When used in option
for
184, this sub-option
the
must
sub-option, that is,
network
call
sub-option 1
used
for
Note
be
the
first

Advertisement

Table of Contents
loading

Table of Contents