wtw pH/Oxi 340i Operating Manual page 45

pH/Oxi 340i
Switching off AutoStore
TDS UpH O
S
1 9 9 9
Time Baud
r
F e
Day.Month No.
Year Ident
Tref25 Tref20 AutoCal DIN
LoBat nLF Lin Cal AutoCal TEC
6 Set the required ID number with < > < >.
7 Confirm with <RUN/ENTER>.
The measuring instrument switches to the last active measur-
ing mode and starts the measuring and saving procedure. Au-
toStore flashes on the display.
As soon as all of the 500 storage locations are occupied, AutoStore is
terminated (Int 1 = OFF). If there are not enough storage locations
available for your measurements:
l Output and backup the data storage (see page 46) and
l Clear the memory (see page 51).
Note
The AutoStore function is interrupted if you start other functions, e.g.
output the data storage. After the function is finished, the AutoStore
function is continued. By this, however, temporal gaps in the recording
of the measured values will occur.
Switch AutoStore off by:
l setting the save interval (Int 1) to OFF, or
l switching the measuring instrument off and then on again.
Sal
mV/pH
% mg/l
S/
m
cm
mbar M cm
1/ cm Sal
1
°
C
/
% K
TP
° F
Auto Store
ARng
AR RCL
Operation
45