Cisco MGX 8950 Installation Manual page 6

Hide thumbs Also See for MGX 8950:

Installation Procedures

•

Install Stability Plate for Seismic Anchoring

You can anchor your Cisco-supplied rack or cabinet to the floor with an optional stability plate designed

for seismic anchoring.

These instructions are specific to a Cisco-supplied cabinet, but can be used for anchoring a

Note

Cisco-supplied rack. If you are not installing your system in a Cisco-supplied rack or cabinet, anchor

your third-party rack or vendor cabinet according to the third-party vendor documentation.

The slots in the stability plate use up to 5/8-inch anchor bolts.

When moving a Cisco-supplied cabinet, do not push the cabinet at its sides. Instead, grip its front or

Caution

back edges.

Complete the following steps to anchor your Cisco cabinet to a stability plate:

Drill holes into the floor to install the stability plate. See

Step 1

Cisco MGX 8950 Hardware Installation Guide

3-6

Connect the MP Connection, page 3-53

Connect the LAN1/2 Ports, page 3-54

Verify EMI Compliance, page 3-55

Chapter 3

Installing a Cisco MGX 8950

Figure 3-1

for the dimensions.

Release 3, Part Number 78-14147-02 Rev. A0, November 2002