Cisco MGX 8950 Installation Manual page 47

Chapter 3 Installing a Cisco MGX 8950
Complete the following steps to connect an international AC power cable to the switch:
Insert the female connector into the AC tray receptacle, as shown in
Step 1
Figure 3-30 AC Power Tray Cable (International)
Captive
Twist the plug clockwise to secure.
Step 2
Loosen the nut on the black strain relief clamp and then slide the metal housing over the plug.
Step 3
Insert the metal tabs (located on both sides of the housing) into the slots found on either side of housing
Step 4
into receptacle and then push down on the housing to secure it.
Tighten the thumbscrew at the top of the housing by hand.
Step 5
Tighten the nut on the strain relief to secure the cable to the housing.
Step 6
Insert the other end of the cable into the wall outlet.
Step 7
If you are using a secondary (redundant) power supply, repeat
Step 8
AC power cable.
Release 3, Part Number 78-14147-02 Rev. A0, November 2002
DC OUT
AC IN
screw
Strain-relief nut
AC IN
Tabs Slots
Cisco MGX 8950 Hardware Installation Guide
Installation Procedures
Figure 3-30.
To outlet
Step 1 through Step 7 for the other
3-47