Cisco MGX 8950 Installation Manual page 41

Chapter 3 Installing a Cisco MGX 8950
Route the cable outside the cable management brackets, then insert the other end of the cable labeled
Step 3
"PEM 1 J1" into the primary (bottom) PEM receptacle labelled "J1."
Push the connector in to seat it
Tighten the captive screws firmly by hand.
Step 4
Insert the connector labeled "Card Cage B1" into the card cage receptacle labeled "PSB 1."
Step 5
Push the connector in to seat it.
Tighten the captive screws firmly by hand.
Step 6
Insert the other end of the cable labeled "PEM 2 J1" into the secondary (top) PEM receptacle labeled
Step 7
"J1."
Tighten the captive screws firmly by hand.
Step 8
Insert the connector labeled "Card Cage B2" into the card cage receptacle labeled "PSB 2."
Step 9
Push the connector in to seat it.
Tighten the captive screws firmly by hand.
Step 10
Insert the other end of the cable labeled "PEM 2 J2" into the secondary (top) PEM receptacle labeled
Step 11
"J2."
Push the connector in to seat it.
Tighten the captive screws firmly by hand.
Step 12
Insert the connector labeled "Card Cage A2" into the card cage receptacle labeled "PSA 2."
Step 13
Push the connector in to seat it.
Tighten the captive screws firmly by hand.
Step 14
Route cable outside the cable management system brackets, then insert the other end of the cable labeled
Step 15
"PEM 1 J2" into the primary (lower) PEM receptacle labeled "J2."
Release 3, Part Number 78-14147-02 Rev. A0, November 2002
Cisco MGX 8950 Hardware Installation Guide
Installation Procedures
3-41