Cisco MGX 8950 Installation Manual page 43

Hide thumbs Also See for MGX 8950:

Chapter 3

Installing a Cisco MGX 8950

Installation Procedures

Figure 3-24 Power Interconnect Connections for DC

DC power

interconnect

cables

Connect the Back Cards

Connect the interfaces from the back cards to the appropriate end device. See

Appendix B, "Cabling

Summary"

for cabling specifications and pinouts.

Once you have connected your back cards, route the cables through the cable management assembly. The

upper card set cables run to the upper cable management panel, and the lower card set cables run to the

bottom cable management panel.

Figure 3-25

shows cables routed through the upper cable

management panel.

Cisco MGX 8950 Hardware Installation Guide

3-43

Release 3, Part Number 78-14147-02 Rev. A0, November 2002