Table of Contents
Advertisement
CRS-150 1:1 Redundancy Switch
Installation
Inspect the equipment for any possible damage incurred during shipment. Contact the
3
carrier and Comtech EF Data immediately to submit a damage report if damage is evident.
4
5
2.2
Rack-Mounting the CRS-150
The CRS-150 is designed to be mounted into the rear of a rack, behind the CDM-600 modems.
This typical configuration is shown in Figure 2-1.
Figure 2-2. Typical CDM-600/CRS-150 1:1 Redundancy Installation
Once the CRS-150 has been installed into operating position, it will be ready for configuration and
cabling connections. Please refer to Chapter 4. MODEM AND SWITCH CONFIGURATION
and Chapter 5. CABLES AND CONNECTIONS for further information.
Review the Installation and Operation Manual carefully to become familiar
with operation.
Proceed to Section 2.2 Rack-Mounting the CRS-150.
2–2
Revision 2
MN/CRS150.IOM
Advertisement
Table of Contents
