Component Layout; Ada / Ansi / Ul - Assa Abloy Norton LEO 5700 Series Installation And Instruction Manual

BREAKER SWITCH
ON/OFF SWITCH
POWER INPUT
IEC C14 APPLIANCE INLET
Included with 5710 and 5740
9/64" HEX
DRIVE SOCKET
SCREW
SLIDE ARM
TUBE
BUFFER STOP
Americans With Disabilities Act (A.D.A.)
These door operators can be installed and adjusted to conform with
A.D.A. regulations.
ANSI Standards
ANSI A117.1 – These door operators permit door
assemblies to conform to the requirements of this
specification "for buildings and facilities – providing
accessibility and usability for physically
handicapped people".
• ANSI A156.19 – These products are designed to conform to this
specification "for power assist and low energy power
operated doors".
80-9359-0002-020 (01-12)

Component Layout

MOTOR ASSEMBLY
1600 SERIES
CLOSER BODY
ACCESSORY
TERMINAL
(4-POSITION)
SLIDE ARM
ROD
SLIDER
SLIDE TRACK
ASSEMBLY
MAIN ARM / SLIDE
UNIT ASSEMBLY
ADA / ANSI / UL Information
CHAIN
PINION EXTENSION /
CLUTCH ASSEMBLY
Included with 5730 and 5740
SHOE / ADJUSTING
ROD ASSEMBLY
ADJUSTING
TUBE
– "PAS" Function is designed to meet or exceed all of the
requirements for the "Power Assist Door".
– "POR" Function is designed to meet or exceed all of the
requirements for the "Low Energy Power Operated Door".
U.L. Listing
Underwriters Laboratories, Inc. listed for use on
fire and smoke barrier
120VAC (60Hz) power input is supplied through
the normally closed alarm contacts of a
compatible UL Listed alarm system or alarm
panel.
INVERTER
BACKPLATE
REED SWITCH
OPEN / CLOSE
POSITIONING
MAGNETS
POWER SUPPLY CORD
(125V / 10A RATED 18AWG
18 INCHES MAX., NEMA 5-15P
AND IEC320-C13 CONNECTORS.
CORD MUST BE UL LISTED.)
CONNECTING LINK
BUSHING ASSEMBLY
FOREARM
SCREW
MAIN ARM
door assemblies when the
SHOE
Page 3