IridiTRAK Installation & User Manual
IridiTRAK Configuration
NOTE:
1. The USB cable from the PC will supply phantom power to
perform most configuration items, without the need for applying
power to the "I/O" port pins. However, in this mode it will not be
fully operating to send messages etc.
2. The IridiTRAK unit is pre-installed by the factory for a default
mode of operation, and changes to this configuration may not be
required.
Install:
1. Download the "IridiTRAK Mangement System" (IMS) from
http://beamcommunications.com/ims
2. Unzip to your hard disk then install the IMS.
Configure:
1. Connect PC to IridiTRAK "Config" Port via USB cable (provided).
2. IridiTRAK can self-power from the USB Connection from the PC for
configuration purposes.
3. Launch the "IridiTRAK Management System" (IMS) and follow instructions
to configure.
Page 33 of 46
USB
Connector
(mini-B)