Table of Contents
Advertisement
IridiTRAK Installation & User Manual
Exceptions
Will NOT send a position report when:
• Alarm has been triggered (push button or man down pendent)
• Ignition is OFF
• No Iridium signal
• Message Queue is full
Sleep Mode
Sleep mode activates by the IridiTRAK unit shutting down the Iridium transceiver and
GPS to consume less power, and draws about 20mA input current.
The unit enters sleep mode:
• Ignition OFF and the units alarm has not been triggered
What will cause the unit to exit sleep mode:
• Ignition ON
• Any alarm triggered by the Alarm button or man down pedant
Time allowed before unit goes to sleep:
• Unit will allow X minutes to send any queued messages
• After X minutes all the remaining messages will be deleted
NOTE: The IridiTRAK unit will NOT enter sleep mode when the USB
cable connection to the PC is present. Sleep mode will be entered as
soon as USB is removed (and the above conditions are also met).
Remote Commands
The unit will handle the following remote commands.
• Cancel triggered alarm
• Change tracking message interval
• Change emergency message interval
• Change time to allow after Ignition OFF
• Change PIN
• Acknowledge emergency message is received.
• Remote polling
All remote commands will be verified by the PIN.
Cancel triggered alarm and Remote polling remote commands received by the unit
will initiate an action and the unit will send an acknowledgment response.
It will not send an acknowledgment response if:
• Ignition is OFF
• Unit is powered off.
Page 25 of 46
Advertisement
Table of Contents
