Table of Contents
Advertisement
IridiTRAK Installation & User Manual
Mounting the IridiTRAK Unit
The IridiTRAK enclosure has two (2) slotted mount holes on each side, of 4mm
diameter. Self tapping screws (eg. #6), or M3 or M4 machine screws/bolts can be
used to mount the IridiTRAK to a flat surface.
NOTE:
o Mount the IridiTRAK on a clean, even surface.
o Use the correct type of screws.
o If mounting on brick or poured concrete surface, let the cement
o If mounting on a wooden surface, make sure the wood is
o Leave enough room around the unit to allow unhindered access
o Do not install the unit in a permanently concealed recess. You
To ensure reliable sturdy fixing:
completely dry before you mount the unit.
structurally sound.
to the rear panel.
must be able to access and remove the unit should future
service/configuration be required.
Page 18 of 46
Advertisement
Table of Contents
