Table of Contents
Advertisement
IridiTRAK Installation & User Manual
Powering Up
When all previous installation steps have been completed, confirm that the
antenna(s) are connected and the power loom active. Once power is connected, the
IridiTRAK LED lamp will start to operate, and the GPS, and Iridium engines will
attempt to register to the service providers, and acquire lock.
Status LED
*One (1) LED lamp are present on
the front Face, and enabled on the
IridiTRAK.
This LED displays the status of both
Iridium and GPS signals, as well as
system error mode, by varying the
flashing and colour.
LED Lamp
Status
OFF When unit is in Sleep MODE
LED
[Iridium Status]
[GPS Status]
[System Status]
In Sleep mode (power-saving) LED's will be OFF.
With no external power, LED's will be OFF.
Status Description
no signal.
Flashing Red
not registered, trying to register with
Flashing Green
registered, ready.
Solid Green
not locked, trying to acquire GPS fix.
Blinking Red
locked, ready.
Blinking Orange
system error.
Solid Red
Page 23 of 46
Iridium network.
(Flash rate: 1.5sec off, 1.5s on)
(Blinking rate: 1sec off, 0.3s on)
Advertisement
Table of Contents
