Table of Contents
Advertisement
IridiTRAK Installation & User Manual
Functionality of the IridiTRAK
Power Loss
The unit stores its operational state for seamless function through a power failure.
Emergency Messages
Send an emergency message every X minutes (default 5min intervals) when any of
the following happens:
• Alarm button is pressed
• Man down pendent goes into triggered state
The unit has one emergency state, irrelevant of what triggered the alarm. When
Emergency is turned ON, unit will not differentiate between Alarm button pressed
and Man down pendent; both will be treated as only one Emergency.
Emergency messages will survive loss of power and continue to be resent once
power is reapplied.
The first emergency messages will be sent as soon as the unit goes into alert state
(alarm button or man down pendent). It will try to send a message for 2 hours and
then if unsuccessful drop the message after this time period. This first message will
contain a snapshot of the message contents when the alarm occurred. Once this
initial message has been transmitted the unit will then send emergency messages
every x minutes. These messages will contain current information at the time of
sending.
Emergency Messages will continue to be sent unless:
• A remote command message is received instructing the alarm to be canceled.
Ignition ON/OFF Messages
The unit will send a message when Ignition goes high.
The unit will send a message when the Ignition goes low.
Exceptions
Will NOT send a position report when:
• No Iridium signal (Unit will keep trying for 2 hours then drop message)
• Message Queue is full (will be overridden by high priority messages)
Position Reports
Send a position report every X minutes (0-1440). Default is15min
Page 24 of 46
Advertisement
Table of Contents
