Table of Contents
Advertisement
IridiTRAK Installation
This chapter explains how to install your IridiTRAK.
WARNING:
you install the cables. If you do not, the IridiTRAK may be damaged.
Please handle electrostatic sensitive components with care, to avoid
electro-static discharge.
Please remove the IridiTRAK unit and other contents from their packaging, and place
the products on a clean, cleared desktop or work bench.
IridiTRAK Wiring Connections
The IridiTRAK is provided with a wiring loom which connects to the DC power
source, and also offers various inputs and outputs that can be utilised. If these extra
inputs and outputs are not required for your particular application, please DO NOT
connect these wires.
Before installing or connecting the IridiTRAK, please read the following thoroughly to
ensure a quality installation.
WARNING:
MAKE THE CORRECT CONNECTIONS
Failure to make the proper connections may result in fire or product damage.
USE ONLY IN NEGATIVE CHASSIS GROUNDED VEHICLES.
(Check with your dealer if you are not sure.) Failure to do so may result in
fire, etc.
BEFORE WIRING, DISCONNECT THE CABLE FROM THE NEGATIVE
BATTERY TERMINAL.
Failure to do so may result in electric shock or injury due to electrical shorts.
DO NOT ALLOW CABLES TO BECOME ENTANGLED IN
SURROUNDING OBJECTS.
Arrange wiring and cables in compliance with the manual to prevent
obstructions when driving. Cables or wiring that obstruct or hang up on
places such as the steering wheel, shift lever, brake pedals, etc. can be
extremely hazardous.
DO NOT SPLICE INTO ELECTRICAL CABLES.
Never cut away cable insulation to supply power to other equipment. Doing
so will exceed the current carrying capacity of the wire and result in fire or
electric shock.
DO NOT DAMAGE PIPE OR WIRING WHEN DRILLING HOLES.
Make sure the power to the product is switched off before
Page 14 of 46
IridiTRAK Installation & User Manual
Advertisement
Table of Contents
