Burner Installation - Eclipse ThermJet TJSR0020 Installation Manual

Burner Installation

Step 1
Refer to Quick Guide 208 for unpacking information.
Step 2: Mounting Extension Installation
The mounting extension must be bolted to the casing of
the furnace. Four studs must be provided on the furnace
casing to mate with the mounting extension. In order to
ensure proper alignment of the mounting flange:
1. Center the mounting extension on the opening in the
furnace wall.
2. Ensure the face of the mounting extension is
perpendicular to the center line of the opening.
3. Rotate the mounting extension such that it is square
with respect to the vertical center line of the clearance
hole in the furnace.
4. Bolt mounting extension to the furnace casing. See
Figure 3.2.
Insulation
Figure 3.2 Mounting Extension Installation
Mounting
Extension
Figure 3.3
Step 3: Exhaust Tube Installation
1. Place gasket (a) over the exhaust tube.
2. Slide exhaust tube through mounting extension flange
into the furnace.
3. Place gasket (b) against exhaust tube flange. Use
adhesive spray to hold gaskets in place. See Figure
3.4.
4. Gently place the adapter ring over the flange of the
exhaust tube. The recess on the adapter ring must
face the exhaust tube flange. The adapter ring should
sit flush with the mounting extension.
5. Bolt adapter ring to mounting extension.
8
NOTE: Use anti-seize compound on all bolts when
assembling.
■ Ceramic exhaust tube must be secure between
mounting extension and adapter plate. If not,
exhaust tube may break.
6. Complete preparation inside the furnace. See Figure
3.1
Step 4: Burner Installation
It is important to use mechanical lifting assistance when
installing the burner. Do not allow the burner to become
tilted during installation. See Figure 3.6.
Furnace
Studs
Mount burner and gasket in the exhaust tube (see Figures
3.5 and 3.6) by aligning holes in exhaust housing with
studs on mounting extension.
Eclipse ThermJet Self-Recuperative, V5, Installation Guide 208, 2/4/2013
Exhaust
Tube
Gasket a
Adapter
Ring
Gasket b
Figure 3.4
CAUTION
Figure 3.5
Mounting
Extension