Table of Contents
Advertisement
Adjusting Flush
Trimmer
Flush Trimming Unit Adjustment
The flush trimmer trims excess height off of the
upper and lower edges of newly applied edge-
banding, making it flush with the top and bottom
of the workpiece.
The flush trimmer consists of two cutterheads
(one upper and one lower) that must each be
separately adjusted toward or away from the
workpiece, according to the edgebanding thick-
ness. Always adjust upper and lower cutterheads
equally.
To adjust flush trimmer:
1.
DISCONNECT MACHINE FROM POWER
AND AIR!
2.
Carefully measure thickness (in millimeters)
of edgebanding you intend to use.
3.
Rotate each flush trimmer adjustment knob
until number displayed in readout equals
thickness of edgebanding (see Figure 47).
Note: Rotate knobs counterclockwise to
move flush trimmers closer to workpiece;
rotate knobs clockwise to move them farther
away.
Numerical
Readouts
Adjustment
Knobs
Figure 47. Location of flush trimmer adjustment
knobs (rear access cover opened for illustration
purposes).
Model G0854 (Mfd. Since 08/18)
Installing
Edgebanding Coil
The edgebanding coil (not included) is a
coiled strip of wood or plastic veneer that is
automatically fed into the edgebander and glued
to the workpiece edge during the edgebanding
process. The Model G0854 Automatic Edgebander
uses edgebanding tape from
For best results, the edgebanding tape width
must be slightly greater than the workpiece thick-
ness. The excess edgebanding tape is auto-
matically trimmed flush with the workpiece during
operations.
The edgebanding tape thickness affects machine
setup. Before installing the edgebanding coil, the
following components should be checked and,
if necessary, adjusted, depending on the edge-
banding tape thickness:
Infeed fence position (see Page 35)
•
Glue spindle position (see Page 36)
•
•
Upper and lower flush trimmer positions
To install edgebanding coil:
1.
DISCONNECT MACHINE FROM POWER
AND AIR!
2.
Loosen edgebanding height knobs on intake
guides (see Figure 48), raise knobs to allow
room for edgebanding tape, then tighten to
secure.
Edgebanding
Height Knobs
Figure 48. Location of edgebanding height
knobs.
⁄
"–1
⁄
" wide.
1
3
2
4
Intake
Guides
-37-
Advertisement
Table of Contents
