Grizzly G0854 Owner's Manual page 42

7. Use temperature UP/DOWN keys to set glue
pot temperature according to glue manufac-
turer's instructions. Wait for glue pot to reach
at least 180° C (356° F), then press glue
spindle ON button to turn motor ON (see
Figure 52).
Wait for
Glue Spindle
Number
ON Button
to Reach
180°C
Glue Temp.
Up/Down Keys
Figure 52. Location of edgebanding controls.
8.
Wait for glue pot to reach working tempera-
ture. Machine is now ready to begin edge-
banding.
9. Press panel feeder and flush trimmer ON but-
tons to turn motors ON (see Figure 52).
10. Place straight edge of workpiece on infeed
end of table and press it firmly against infeed
fence, as shown in Figure 53.
Figure 53. Example of placing workpiece on
table in preparation for edgebanding.
-40-
Flush Trimmer
ON Button
Panel Feeder
ON Button
Workpiece
11. Carefully slide workpiece under panel feeder,
making sure to keep hands and fingers away
from moving conveyor belt. When you feel
panel feeder grab workpiece, allow panel
feeder to advance workpiece through to
outfeed end of table (see Figures 54–55).
Tip: For long workpieces, it may be neces-
sary to support trailing end of workpiece with
your hands or a roller stand until it begins to
move across table.
Then, as workpiece begins to exit outfeed end
of table, support leading end of workpiece
with hands or roller stand while panel feeder
continues to feed workpiece through.
Outfeed
End
Figure 54. Example of panel feeder advancing
workpiece.
Figure 55. Location of conveyor belt (panel
feeder shown in open position for illustration
purposes).
12. Receive edgebanded workpiece at outfeed
end of table (see Figure 54). Allow panel
feeder to completely finish feeding workpiece,
then remove workpiece from table.
Model G0854 (Mfd. Since 08/18)
Keep Hands
and Fingers Away
from This Area
Conveyor Belt
Viewed from
Under Panel
Feeder