Grizzly G0854 Owner's Manual page 29

8. Install (1) M10-1.5 hex nut and (1) 10mm
fender washer removed in Step 6 on coil sup-
port stud (see Figure 24), and tighten hex nut
against top of coil support arm, then tighten
hex nut against bottom of support arm (see
Figure 24).
Stud
Fender
Washer
Hex Nut
Fender
Washer
Figure 24. Stud secured against coil support
arm.
9. Install coil support assembly on stud and
secure with remaining M10-1.5 lock nut and
10mm fender washer removed in Step 6 (see
Figure 25).
Lock Nut
Fender
Washer
Figure 25. Coil support assembly installed.
Model G0854 (Mfd. Since 08/18)
Coil
Support
Arm
Hex Nut
Coil Support
Assembly
10. Remove slide nut from each of four guide
roller assemblies (see Figure 26).
Slide Nut
Figure 26. Guide roller assembly and slide nut
(1 of 4).
11. Place slide nut under slot in coil support
assembly, then thread guide roller with
washers into nut from above and tighten, as
shown in Figure 27. Repeat with remaining
three guide roller assemblies in each of the
remaining slots.
Guide Roller
Washer
Figure 27. Guide roller installed in coil support
slot.
Guide
Roller Assembly
(1 of 4)
Slot
Slide Nut
-27-