Grizzly G0854 Owner's Manual page 28

4. Install handwheel on panel feeder elevation
shaft (see Figure 20), and secure with fas-
teners removed in previous step.
x 1
Figure 20. Panel feeder elevation handwheel
installed.
5. Remove (2) pre-installed M8-1.25 x 20 cap
screws, (2) 8mm lock washers, and (2) 8mm
flat washers, then use them to install coil sup-
port arm (see Figure 21).
Coil
Support
Arm
Figure 21. Coil support arm installed.
-26-
6. Remove (1) pre-installed M10-1.5 lock nut,
(1) pre-installed M10-1.5 hex nut and (2)
10mm fender washers from coil support stud
(see Figure 22).
Note: Leave (1) M10-1.5 hex nut and
(1) 10mm fender washer installed at end of
stud.
Remove This Lock Nut &
Fender Washer and Hex
Nut & Fender Washer
Figure 22. Coil support stud.
7. Thread stud up through bottom of coil support
arm (see Figure 23).
Stud
x 2
Hex Nut
Figure 23. Stud threaded into coil support arm.
Do Not Remove
This Hex Nut &
Fender Washer
Coil Support
Arm
Fender
Washer
Model G0854 (Mfd. Since 08/18)