Adjusting Edgebanding Coil Limit Switch - Grizzly G0854 Owner's Manual

Adjusting
Edgebanding Coil
Limit Switch

Adjusting Edgebanding Coil Limit Switch

The edgebanding coil limit switch (see Figure 75)
signals the pneumatic end trimmer guillotine to
move into position and the pneumatic edgeband-
ing coil guillotine to activate. The switch is factory
set, and should not require routine adjustment.
However, after prolonged use, or if edgebanding
results are unsatisfactory, the switch may need
adjustment.
When the leading edge of the workpiece triggers
the switch, the end trimmer guillotine moves into
cut position. When the workpiece passes over
and releases the switch, the edgebanding coil
guillotine activates and the blade severs the edge-
banding from the coil, leaving some excess that is
then trimmed flush by the end trimmer guillotine.
If the edgebanding coil guillotine leaves too much
or too little excess edgebanding, you will need to
adjust the switch.
Guillotine
Switch
Figure 75. Location of guillotine limit switch and
adjustment screws.
Model G0854 (Mfd. Since 08/18)
Adjustment
Screws
Item(s) Needed
Hex Wrench 3mm .............................................. 1
To adjust edgebanding coil limit switch:
1.
DISCONNECT MACHINE FROM POWER
AND AIR!
2.
Unlock and open panel feeder.
3. Loosen adjustment screws (see Figure 75).
— If guillotine leaves too little excess edge-
banding, move switch toward infeed table,
then retighten adjustment screws.
— If guillotine leaves too much excess edge-
banding, move switch toward outfeed
table, then retighten adjustment screws.
Qty
-53-