Pump Control - Wolf WRS-K Installation And Operating Instructions Manual

10.2.7 Pump control

Pump control
Pump, DHW
Operating mode:
Demand-dependent
Esc BACK SELECTION
34
10. Operating level 2
Standard mask
control
PS-01
The heating circuit / cooling circuit pumps can be operated in various modes.
Heating circuit pump:
- Demand-dependent (on where there is heat demand, otherwise off).
- Weather-compensated: where outside temperature < set value, pump on.
DISPLAY
- Constant operation: pump always on when the system is operational.
Cooling circuit pump:
- Demand-dependent (on where there is cooling demand, otherwise off).
- Constant operation: pump always on when the system is operational.
You may also set a run-on time for both pumps.
Parameter
Pump, DHW, operating mode:
Pump, DHW, limit, outside temperature
Heating valve control with weather-
compensated pump operating mode
Min. heating valve control during
operation
Pump, DHW, run-on time
Pump, cold water, operating mode:
Pump, cold water, run-on time
Pump reheater bank run-on time
Cyclical pump start
After hours
After seconds
Main menu
Esc
Demand-dependent /
Outside temperature
/ Constant operation
Demand-dependent /
Constant operation
Heating contractor
Setting range Factory setting
Demand-
dependent
-20 - 15 °C
0 - 100 %
0 - 100 %
0 - 60 min 2 min
Demand-
dependent
0 - 60 min 2 min
0 - 60 min. 2 min.
0:00 - 23:59 h 5:00 h
2 - 99 h
0 - 99 s
3062878_201707
Pump
2 °C
0 %
0 %
24 h
5 s