Installation / Electrical Connection Of Bmk Programming Module; Wall Mounted Installation - Wolf WRS-K Installation And Operating Instructions Manual

6.1 Wall mounted
installation
3062878_201707
6. Installation / Electrical connection,
programming module
To mount the programming module on the wall, proceed as follows:
1. Mount the wall mounting base on the wall using screws (A).
2. Install the cable and secure using the strain relief (B) supplied.
3. Guide the ends of the cable through aperture (C) in the back panel of the
programming module.
4. Secure the back panel to the wall mounting base using screws (D).
5. Connect the cable as follows:
VL / GND
Supply voltage
via KLM control unit
(see wiring diagram)
6. Secure the programming module to the back panel using screws (E).
7. Fit the cover (F; clicks into place).
(A)
(B)
(C)
+
Databus (pLAN) Databus (pLAN)
Tx+/Rx+
(D)
(E)
-
Tx-/Rx-
(F)
11