9.2 Operating data
9.3 Main menu
Main menus
Standard settings
Display
Time functions
Contractor
Esc BACK
SELECTION
9.3.1 Standard settings
Set temp value for
manual mode
STANDARD SETTING
Set temp value for
manual mode
21.0°C
Esc BACK
SELECTION
Fan stage / fan enable
for manual mode
STANDARD SETTING
Fan, manual mode
< OFF >
Esc BACK
SELECTION
16
9. Operating level 1
Pressing Prg leads to the operating data, where pressing
set and actual system values in sequence.
Overview:
→ Extract air / set room temperature
→ Set temp. set value transducer
→ Room temperature
→ Extract air temp
→ Set temp, vent. air
→ Vent. air temperature
→ Set value humidity (room / extract air)
→ Set value humidity (ventilation air)
→ Rel. humidity (room)
→ Rel. hum., extract air
→ Rel. hum., vent. air
→ Pressure
→ Flow rate
→ Proportion fresh air
By pressing
Esc
Esc
the menu points displayed in the overview. After selecting the required menu point,
you enter the required sub-menu by pressing
standard display. If no adjustment is made for more than 2 minutes, the standard
display will return automatically.
Overview:
DISPLAY
→
Standard settings
→ Display
→ Time functions
→ Heating contractor
Standard mask
The most fundamental functions of the air handling system, such as 7-day program,
backup mode, night ventilation and natural cooling can be enabled or disabled
here. Furthermore, the set temperature and the fan speed as well as the fresh air
proportion for manual mode are determined in the standard settings.
Pressing
Pressing
highlights the temperature that can then be changed with
of 0.5 °C. Finally confirm the selected value with
GE-01
Please note The selected set temperature only applies in manual mode.
DISPLAY
Pressing
changes the fan stage for stepped fans; for variable speed fans the fan
will be enabled or disabled.
GE-02
Please note The selected value only applies in manual mode.
DISPLAY
you reach the main menu. There, by pressing
Main menu
Esc
enables you to select the following standard settings in sequence.
displays the following
you select from
. Pressing
Esc
Esc
returns you to the
Standard settings
.
3062878_201707
in steps