Verifying The Installation - Dometic 9200 Series Installation Instructions Manual

Power Awning
7.6 Securing the awning to the railing
23
➤ Open and close the awning 4 – 5 times.
➤ Verify alignment and hardware nesting. Adjust the
hardware if necessary.
I
Repeat this procedure as needed.
7.7 Installing the plastic covers
25
Plastic Cover
LH
➤ Snap the plastic covers into position at each end of
the awning to complete the installation.

8 VERIFYING THE INSTALLATION

8.1 Testing operation
27
➤ With power applied to the awning, open and close the awning to verify that each part is functioning correctly.
I
Refer to the Operating Manual for securing the awning for travel.
EN
Plastic Cover
RH
24
Awning
Fabric Edge
➤ Pull the right edge of the awning fabric
approximately 1/4" beyond its position. Then
secure the fabric with one #6 x 7/16" TEK screw
through awning rail (approximately 2" from the
fabric edge).
➤ Repeat for the LH side.
26
#6 x 7/16" TEK Screw
Awning
Rail
2"
16