Advertisement
INSTALLATION OF BOTTOM MOUNTING
INSTALLATION OF BOTTOM MOUNTING
INSTALLATION OF BOTTOM MOUNTING
INSTALLATION OF BOTTOM MOUNTING
INSTALLATION OF BOTTOM MOUNTING
BRACKETS
BRACKETS
BRACKETS
BRACKETS
BRACKETS
IMPORTANT: Always mount into solid under-structure.
IMPORTANT: Always mount into solid under-structure.
IMPORTANT: Always mount into solid under-structure.
IMPORTANT: Always mount into solid under-structure.
IMPORTANT: Always mount into solid under-structure.
1. Location of bottom mounting brackets must be set so
that upright legs are vertical when retracted from case.
(FIG. 7) To determine the location of bottom mounting
bracket, fully extend awning. Remove arms from lead
rail and place against side of vehicle. Loosen black
adjustment knob and extend arm until lead rail is at
desired height. Mark location on side of vehicle to
maintain this height (FIG. 8)
FIG. 7
FIG. 7
FIG. 7
FIG. 7
FIG. 7
90
2. Using the holes in the brackets as a guide, mark and
drill using a 5/32" drill bit. Secure each bracket to
vehicle using pan head sheet metal screws provided.
If mounting area sub-structure is not solid, use backup
plate inside the vehicle. (FIG. 8)
FIG. 8
FIG. 8
FIG. 8
FIG. 8
FIG. 8
o
o
90
DESIRED HEIGHT
DESIRED HEIGHT
DESIRED HEIGHT
DESIRED HEIGHT
DESIRED HEIGHT
OTHER INSTALLATION NOTES
OTHER INSTALLATION NOTES
OTHER INSTALLATION NOTES
OTHER INSTALLATION NOTES
OTHER INSTALLATION NOTES
1. To prevent water leakage, always use silicone sealant
where each fastener enters the sidewall or roof of the
vehicle.
2. To prevent damage to the fabric during drilling, unroll
the fabric completely and adjust the legs to their highest
position while keeping the fabric horizontal.
3. DO NOT over-tighten fasteners. This will cause them to
"strip out" and severely weaken their holding ability.
SILICONE
4
OPTIONAL
Advertisement
