Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Chiayo UDR-500
Summary of Contents for Chiayo UDR-500
-
Page 2: Parts And Functions
Front and Rear Panel Switches & Controls 12 A receiver cannot receive signals from two or more transmitters simultaneously. UDR-500 RECEIVER Turn the transmitter off when it is not in use. Remove the batteries if it is not to be used for a... - Page 3 UDR-500 is a 1/2 19" casing and specially designed 19" rack mount adapters (optional) is available for rackr installation purposes. Installation instructions are as follow. RF Interference If you encounter receiving interference (from other than an operating TV station), often it can be o v e r c o m e b y a d j u s t i n g t h e r e c e i v e r ' s s q u e l c h c o n t r o l , a s d e s c r i b e d o n b e l o w .
-
Page 4: Receiver Installation
For best operation, the receiver should be placed at least 1m above the ground and 1m away from a wall or metal CHIAYO surfaces to minimize reflections. The transmitter should UDR-1000 also be at least 1m away from a wall or metal surface to minimize reflections. - Page 5 User is free to choose the various this page appears. input sources but is advised to take note that connector used must be compatible to each other. The pin CHIAYO configurations for mini XLR connector is as follow. UDR-1000 Remark : Brand name and Model number are factory preset.
- Page 6 Press MENU until These microphone have a module design. To change or replace a capsule, Open the grill to pull out and plug in the A 801.100MHz B this page appears. capsule as shown in the following figure. RF-----------AF------------ Press SET button for 2 seconds to enter the SET mode and the following display will appear and the cursor will flash.
- Page 7 BATTERY SELECTION DISPLAY To adjusting the Volume of the system buttons at the front panels serve as the Volume Controls of the Press button to go to the display. receiver. It can be pressed at any moment. Whenever it is pressed, the following display will appear : NiMH : X NiMH : X...
-
Page 8: Scan Function
SCAN function Channel / Frequency Display The SCAN button has two functions : Press button to go to the display. CH : 01-01 1. Auto Scan 800.000 When SCAN button is pressed, receiver will start the auto scanning function. It will compare 200 of the preset frequencies with the environment and select 40 of them and save it in Group 1 of the 25 groups. -
Page 9: Lcd Displays
Making changes to the various displays Name Display UH-1000 microphone requires 2 pieces of " AA " size batteries to Press button to go to operate. Please insert the batteries according to the correct the display CHIAYO CHIAYO CHIAYO CHIAYO CHIAYO CHIAYO CHIAYO... - Page 10 Lavalier microphone Viewing of the various pages in the LCD display Mic clip First press power ON switch for about 2 seconds and release the button,the following page will appear: CHIAYO CHIAYO CHIAYO UH-1000 UH-1000 UH-1000 Remark : Brand name and model number is factory fixed and not user-changeable.
Need help?
Do you have a question about the UDR-500 and is the answer not in the manual?
Questions and answers