Larsen & Toubro C*2000 Series User Manual page 92

Restart after fault reset
Group Code
Drive group drv
Function
H21
group 2
Set H21 to 1.
When drv is set to terminal operation (1 or 2) with FX or RX ON, the motor starts acceleration
after the fault is reset.
This parameter is inactive when drv is set to 0 {Run via keypad} or 3 {RS-485 Communication
operation}.
When this function is used, fault is reset via terminal or keypad, the motor starts immediately.
Particular attentions shall be directed to this function due to potential hazard.
F re q .
R e s e t
R u n C o m m a n d
Cx2000 AC Drive
Item
Drive mode
Restart after fault reset
selection
Warning
W h e n H 2 0 = 0
Chapter 7 Basic Functions
Set value Range Initial
1,2 0 ~ 3 1
1 0 ~ 1 0
W h e n H 2 0 = 1
Unit
7-11