Parameter Setting; Keypad Structure - Larsen & Toubro C*2000 Series User Manual

Chapter 4 Parameter setting

4 Parameter setting

4.1 Keypad structure

Display
FWD
REV
RUN
SET
7-segment
Keys
RUN
STOP/RESET

Up
 Down
 Left
 Right
ENT ENT
Knob
Volume
4-1
Display:
SET/RUN LED
FWD/REV LED
7-segment LED
Key：
RUN
STOP/RESET
Up/Down
Right/Left
Enter
Volume
Lit during forward run
Lit during reverse run
Lit during operation
Lit during parameter setting
Operation data and parameter information are displayed.
Run command
STOP: Stop command during operation,
RESET: Reset command when fault occurs.
Used to move parameter codes or increase parameter values
Used to move parameter codes or increase parameter values
Used to switch parameter groups or move the cursor to the left when the
parameters are written.
Used to switch parameter groups or move the cursor to the right when the
parameters are written.
Used to read, write and keep the parameter values.
The keypad potentiometer V2 is used for frequency setting.
Blinks when a fault occurs
Cx2000 AC Drive