Chapter 2 INSTALLATION & WIRING
2 INSTALLATION & WIRING
2.1 Installation precautions
Handle the inverter with care to prevent damage to the plastic components. Do not hold the inverter by the
front cover. It may fall off.
Install the inverter in a place where it is immune to vibration or extrusion under allowable temperature (-
10 C~ 50 C)
The installation environment of inverter will influence its service life directly, so the inverter shall be used in a
condition with standard specification
The inverter will be very hot during operation. Install it on a non-combustible surface, far away from hot
sources and inflammables.
Mount the inverter on a flat, vertical and level surface. Inverter orientation must be vertical. Also leave
sufficient clearances around the inverter.
Protect from moisture and direct sunlight.
3cm
2-1
Caution
<Ambient Temp Checking Location>
10cm
3cm
10cm
10cm
2mm
3cm
10cm
3cm
Cx2000 AC Drive