Hardware Reset - Siemens CCIC1410 Configuration Manual

6.6

Hardware reset

Siemens Building Technologies
Fire Safety & Security Products
There is a reset button on the back cover of the network camera (see chapter 6.2
Front and rear views of the camera, No. 5). It is used to reboot the network camera
or to reset the network camera to the factory default configuration. Depending on
the functional problem, rebooting may set the network camera back to normal
state. If the problem remains after rebooting, restore the network camera settings
to the factory default and install the software again.
Reboot:
Press and release the reset button. The status LED on the front will blink red.
Restore:
Press the reset button continuously until the status LED on the front blinks in red
and green simultaneously. Note that all settings will be reset to factory default.
Description of the equipment
05.2009
17