Discharge Hood Adjustment - HARVEST FC1545 Operator's Manual

!
DANGER: Keep clear of all power lines. Electrocution can occur without direct
contact with power lines.
!
5. The conveyor has the ability to lift to a 32 degree angle, but will only move
product up to 30 degrees. It has been designed this way to allow easy placement in
the storage facility.
6. Use extreme caution when moving the conveyor into working position. Make sure
everyone is clear of the work area, especially children.
DANGER: Once in place, anchor the intake end or support the discharge end
before using. Failure to do so, can result in damage to the conveyor and/or
serious injury or death as it may tip over during use.
!
7. The wheels should be chocked on both sides of the conveyor.
!
DANGER: Do not attempt to increase the height of the conveyor by positioning
wheels on lumber, blocks, or by any other means.
!
!
3D Discharge Hood Adjustment
The angle of the discharge
hood is adjustable.
Depending on the height at
which the conveyor will
most frequently be used,
you can change the angle by
removing the upper
mounting bolt and tilting
the hood to the best angle.
The figure shows which hole
to use depending on the
angle of the conveyor.
!
!
!
_
! 1 4