Machine Break-In And Operation - HARVEST FC1545 Operator's Manual

!
3A Machine Break-in and Operation
BEFORE STARTING:
1. Read the conveyor operation manual.
2. Tighten wheel bolts to specified torque.
3. Check all fasteners and ensure they are tightened to specified torque levels.
4. Check that all guards are in place, secure, and functional.
5. Check winch and cable for security and operation. There should be at least three
complete wraps of cable around the winch drum in the full down position. The
cable anchor on the winch drum must be tight.
6. The FC1545 Conveyor is designed to have a belt speed of 600 FPM with the gas
engine drive (using a 26 HP engine @ 3600 RPM).
7. During the first 15 minutes of operation, check the conveyor belt alignment to
ensure preset alignment does not vary under loaded conditions. See Maintenance
section 8.3.5
NOTE: A new belt will ear at edges and throw small pieces of belting for the first 5 minutes of
use. This is normal. Check tension and alignment closely during this time. A slower belt speed
is gentler on the product, whereas a higher belt speed increases capacity but may increase
product damage.
!
AFTER OPERATING OR TRANSPORTING FOR 5 MINUTES:
1. Re-torque all fasteners and hardware.
2. Check conveyor belt and drive belts for tension and alignment.
AFTER OPERATING OR TRANSPORTING FOR ½ HOUR:
1. Re-torque all the wheel bolts.
2. Re-torque fasteners and hardware.
3. Check the drive and conveyor belt tension and alignment. Tension or align as
required. See "Maintenance" section.
AFTER OPERATING FOR 5 AND 10 HOURS:
1. Re-torque all wheel bolts, fasteners, and hardware.
2. Check the drive and conveyor belt tension and alignment. Tension or align as
required.
_
! 1 2