MSA G1 SCBA Instruction Manual page 7

(5) Turn on the Motorola APX radio:
For single display radios:
(1-dot) side button on the radio. While continuing to press
the radio button, select
screen. The radio button should continue to be pressed
until the radio information is displayed on the A2 display.
For two display radios:
tooth menu and make the radio visible, then select
Discover devices
radio specific instructions for more detailed instruction on
radio operability.
The Motorola APX radio will be placed into visible mode
while the PC searches for the radio.
(6) The display should now show the Motorola APX radio
being discovered. Select the Motorola APX radio for
which a pairing tag is being created.
(7) Place the target RFID tag on the RFID tag reader/writer.
Write G1 Select the
Tag icon
of the screen.
(8) A
Tag was successfully written
the tag writing process is complete. If this does not
appear, repeat the steps above.
Read G1
Tag icon
(9) To verify the correct information was written to the tag,
select the
the display. A successfully written tag will appear in a
Found Tag
The tag has successfully been created and can now be used
with a G1 SCBA.
G1 SCBA
Operation with Bluetooth Radios
Press and hold the middle
Discover devices
Go into the Motorola radio Blue-
on the A2 screen. Refer to the Motorola
button in the upper right corner
Write G1 Tag
screen will appear when
button in the top right corner of
Read G1 Tag
screen.
on the A2
US
7