M-LOCKS EuroLine Modular Series User Manual page 2

ST3540 Flush Mount, Black only
Cut the 8mm square shaft to an appropriate length. The shaft should stick out of the boltwork
5-8 mm and is secured by using the star washer. NOTE: it is recommended to de-burr, or
even chamfer, the shaft edge after cutting; so it is easier to apply the star washer.
If used with the DirectDrive electronic lock, the shaft should engage approximately 15 mm
into the lock and then the star washer is fitted between the lock and mounting surface. Affix
the shaft in the handle with the provided screw and cover the screw with the label. Turn
boltwork or lock into "OPEN" position. Push the complete unit as shown in the picture into
the locking mechanism and fasten it with two M4 countersunk screws.
M-LOCKS BV Tel: +31 (0)314 376 876
Vlijtstraat 40 ver. 1.1 2013 03 29 Fax: +31 (0)314 376 878
NL-7005 BN Doetinchem 2 of 2 www.m-locks.com